AEG LAVAMAT 62895 - Manual (Page 41)

Open the porthole,
take out the inlet
hose from the
drum and remove
the polystyrene
block fitted with
the adhesive tape
on the door seal.
Fill the smaller
upper hole and the two large ones with the
corresponding plastic plug caps supplied in the
bag containing the instruction booklet.
Important!
All the different plug caps are supplied with
the appliance in the plastic bag containing the
instruction booklet.
Connect the water inlet hose as described
under the paragraph “Water inlet”.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by
carpets, rugs etc.
• Before placing it on small tiles, apply a rubber coating.
• Never try to correct any unevenness in the floor by putting pieces of
wood, cardboard or similar materials under the machine.
• If it is impossible to avoid positioning the machine next to a gas
cooker or coal-burning stove, an insulating panel (85x57 cm) covered
with aluminium foil on the side facing the cooker or stove, must be
inserted between the two appliances;
• The machine must not be installed in rooms where the temperature
can drop below 0.
• The water inlet hose and the drain hose must not be kinked.
• Please ensure that when the appliance is installed, it is easily accessi-
ble for the engineer in the event of a breakdown.
83
Installation
HEC0005 HEC0010
P0002
132974550_gb.qxd 01/02/2007 13.38 Pagina 83