King Technology Prevail System - Manual (Page 11)

Above Ground Filter Installation
Apply pipe thread tape or
sealant to each threaded end
of nipple.
Screw one end of nipple
into the filter return.
Screw either side of
Cycler on to open nipple
end until upright and
secure.
Tighten turning 1 to 2
revolutions with wrench.
DO NOT OVER TIGHTEN.
HOSE
ADAPTER
HOSE
ADAPTER
HOSE ADAPTER
11
Bi-flow valve
design allows
water flow in
either
direction.
4.
6.
1.
2.
3.
7.
MATERIALS NEEDED:
One
Hose
Clamp
Corrosion Resistant
Check Valve
RECOMMENDED:
INCLUDED
WITH CYCLER:
Screw adapter into the
other side of Cycler.Hand
tighten. Finish tightening by
turning 1 to 2 revolutions
with wrench.
DO NOT OVER TIGHTEN.
Apply pipe thread
tape or sealant to
threaded end of hose
adapter.
Attach return section of hose
to the adapter with clamp.
Tighten clamp with
screwdriver.
TOOLS NEEDED:
Screwdriver
When using a Chlorine Pac,
installing a corrosion resistant
check valve is
recommended.
One Hose Adapter
1 1/2" X 1 1/2" X 1 1/4"
One 6" X 1 1/2" TBE
PVC Nipple
One Section of
1 1/2" Flex Hose
(provided with filter)
Pipe Wrench
Pipe Thread Tape
or Sealant
5.