King Technology Prevail System - Manual (Page 6)

Replacing a
Chlorine Pac
Cutting handle from Pac using a cutting tool
or hacksaw
(KEEP OUT OF REACH OF CHILDREN)
B. If using a cutting tool,
place curved section of tool
around the narrow end of
one Pac tower and line up
blade on indent.
A. Find the indent in the
plastic.
C. Squeeze the handles
together. Repeat for other
side.
Indent in plastic
F. If openings are pinched
together, open with fingers
or re-cut closer to the
colored screens inside Pac.
Leave at least 1/4" of plastic
to fit into Cycler base.
E. Whether using a cutting
tool or a hacksaw make
sure the blade comes
straight across on the
indent line for a clean cut.
Finished cut ends
A correct
oval
opening
Avoid a
pinched
opening.
D. If using a hacksaw to
cut the Pac, line up hack-
saw blade on indent and
cut with a smooth sawing
action.
Back of
Cycler
3.
1.
2.
4.
5.
6
CAUTION Read Carefully – USE ONLY the factory recommended replacement Pac. (See
label.) DO NOT USE any other Pac or bulk chemical tablets in the Cycler. Use of any
other product could result in over chlorination, bleached liners, unsafe pool conditions,
fire or explosion. Warranty will be void if the correct Pac is not used.
• Turn off pump. Turn dial to
0. This reduces the flow of
water into the unit when the
cap is open so isolation
valves are unnecessary.
• Unscrew knob to relieve
pressure.
• Remove Cycler cap. Stand
back upon removing cap to
avoid inhaling fumes.
• The Pac is made of HDPE
plastic. When the Pac is empty,
triple rinse in pool water, drain,
and recycle or wrap in
newspaper and discard in trash.