KT&C KPC-HDN300M - Manual (Page 15)

15
7. OSD MANUAL
- MOTION: Motion detection function.
1. RESOLUTION: Enable user to set up resolution
2. SENSITIVITY: Enable user to set up sensitivity.
3. WINDOW USE: Enable user to select to motion area.
4. WINDOW TONE: Enable user to area window tone.
5. X-POSITION : Window Horizontal start position.
6. Y-POSITION : Window Vertical start position.
7. X-SIZE : Window Horizontal width.
8. Y-SIZE : Window Vertical height.
9. INITIAL : Enable user to initialize setting of
MOTION DETECT.
- DISPLAY : Enable user to set up a screen marking
CAM TITLE, MOTION, DZOOM.
1. CAM TITLE: Enable user to set up output in
fixed CAM TITLE.
2. MOTION: Enable user to set up out put of
MOTION on the screen as MOTION ON setting.
3. DZOOM: Enable user to set up output DZOOM ratio.
4. INITIAL: Enable user to initialize of DISPLAY menu.
- SYSTEM
1. DEFECT DET: White pixel detection and
compensation function.
2. DOUT FORMAT: Enable user to set up
digital output format (720p, 1080p).
3. DOUT FPS: Enable user to set up
digital output frame rate.
4.FREQ: Enable user to set up
power-frequency(50Hz, 60Hz).
5. CVBS: Enable user to set up CVBS type NTSC or PAL.
6. APPLY: Enable user to setting of SYSTEM.
7. FACTORY DEFAULT
: Enable user to reset all of the status as the factory default.
8. EXIT
: After saving the current settings in the OSD menu and exit.
HOT KEY
To quickly switch CVBS type(NTSC or PAL), Push LEFT KEY or RIGHT KEY more than
2secends and push SET KEY.
MOTION
> RESOLUTION
SENSITIVITY
WINDOW USE
WINDOW TONE
X-POSITION
Y-POSITION
X-SIZE
Y-SIZE
INITIAL
| | | |||||||| | 1
| ||||| | |||| | 10
ON
1
11
3
39
28
SYSTEM
> DEFECT DET
DOUT FORMAT
DOUT FPS
FREQ
CVBS
APPLY
RETURN
[ 」]
1080P
30
60HZ
NTSC
[ ]
DISPLAY
> CAM TITLE
MOTION
DZOOM
INITIAL
RETURN
OFF
OFF
OFF
When setting of FREQ and DOUT FPS are incorrect, flicker or unnatural images will be caused.
The System menu is not initialized even if factory default was operated.