Clock Audio CAP 002 Line preamp - Manual (Page 2)

Microphone input Connections
Connect your microphone to the PL2 screw terminals:
Connect Phase cold (-) to pin 4.
Connect phase hot (+) to pin 3.
Power supply connections
Connect the supply to the PL2 screw terminals:
Connect (+) Voltage to pin 2.
Connect (-) Voltage to pin 1.
Audio output / Mixer / Auxiliary amplifier Connections
Connect your mixer input / Audio amplifier input to PL1 screw terminals:
Connect ground to pin 1.
Connect phase cold (-) to pin 2.
Connect phase hot (+) to pin 3.
Changing the audio output level (R5)
The audio output level from the CAP002 is preset to give optimal sound level with minimal distortion.
The audio output level can be increased by changing the value of a resistor mounted on the board
(R5 Gain) the values of resistance are shown below:
1K Ohm = Fitted as standard (0dB).
2K Ohm = +6dB more gain.
3.9K Ohm = +12dB more gain.
18.2K Ohm = +18dB more gain.
100K Ohm will give maximum output level.