Forms specifications – CognitiveTPG A760 User Manual
Page 51
Chapter 5: Paper and Supplies
51
A760-D100 10/04
189-9200303 Rev. D A760 Two-Color Thermal/Impact Hybrid Printer: User Guide
Forms specifications
The A760 prints on single- or multiple-part forms in the slip station (up to five-part forms).
Forms and slips must meet the following requirements:
• Front insertion (minimum):
51 mm (2.00") wide
68 mm (2.68") long
• Side insertion (minimum):
203 mm (8.0") wide
51 mm (2.0") long
• Single-ply forms should be on paper that is greater
than 15 pounds
• Multiple-part forms (up to five parts) should be no
thicker than 0.40 mm (0.016") and a minimum
thickness of 0.08 mm (0.003").
Important: Do not use forms containing holes along
the top or right edge.
• Forms for use with flip check (minimum)
51 mm (2.00") wide
70 mm (2.75") long
Slip forms - recommendations
Paper feed direction
Glued portion
1
2
2
3
• The slip form should be flat and void of curls or
wrinkles, especially at the top.
• Considerations for glued edges on slip paper:
a
No glue on bottom edge (1).
b
Right or top edge (2): Paper feeding and insertion
are affected by gluing method, length of edge, and
quality of glue used.
c
Left edge or wide slip paper (3): Skewing may
occur.