Comprehensive CE-HDBT100 - Manual (Page 6)

HDMI Twisted Pair
- 6 -
LINK: Twisted Pair Link status indicator. It will keep on when connection is successful.
IN: When connected with devices support HDCP and work normally this LED will keep on. If devices not
support HDCP, the LED will blink.
3) POWER LED: LED indicator of power. When connect with power, red LED will keep on.
4) TP OUT: Single TP cable connects to TP IN port in CE-HDBT100R.
5) HDMI IN: Connect to HDMI source.
6) IR IN: Connect with IR receiver, the IR signal received from this port can only send out in CE-HDBT100R.
NOTICE: When there is IR receiver connected to this port, the port (1) will be unavailable.
7) IR OUT: Connect with IR sender, the sending IR signal are received from CE-HDBT100R.
8) RS232: RS232 connector.
9) 5V DC: Connect with power supply.
5.2 Receiver Introduction:
1) IR: IR receiver.
2) ON/LINK/IN LED Indicators: All are green LED.
ON: Working status indicator of this device. When the device works fine, the LED will keep blinking. And
it will get off when the device stops work.
LINK: Twisted Pair Link status indicator. It will keep on when connection is successful.