Comprehensive CE-HDBT100 - Manual (Page 7)

HDMI Twisted Pair
- 7 -
IN: When connected with devices support HDCP and work normally this LED will keep on. If devices not
support HDCP, the LED will blink.
3) POWER LED: LED indicator of power. When connect with power, red LED will keep on.
4) TP IN: Single TP cable connects to TP OUT port in CE-HDBT100T.
5) HDMI OUT: Connect to HDMI display, HDMI signal output.
6) IR IN: Connect with IR receiver, the IR signal received from this port can only send out in CE-HDBT100T.
NOTICE: When there is IR receiver connected to this port, the port (1) will be unavailable.
7) IR OUT: Connect with IR sender, the sending IR signal are received from CE-HDBT100R.
8) RS232: RS232 connector.
9) 5V DC: Connect with power supply.
6. Installation Introduction
Step 1: Connect HDMI source (such as Blue-ray DVD) to HDMI IN port of transmitter CE-HDBT100T with HDMI
cable.
Step 2: Connect TP OUT port of TPHD401T and TP IN port of TPHD401R, with single CAT5e/CAT6 cable.
Step 3: Connect HDMI displayer (such as HDTV) to HDMI OUT port of CE-HDBT100R with HDMI cable.
Step 4: Connect DC5V power adaptors to both CE-HDBT100T and CE-HDBT100R.
Step 5: Both CE-HDBT100T and CE-HDBT100R have IR IN and OUT. When one model use for IR signal receiver,
the IR signal must be sent out by the other model.
For example: When “IR IN” of CE-HDBT100T connects with an IR receiver, the IR sender must connect to “IR
OUT” of CE-HDBT100R.
7. Diagram and connection