Comprehensive CSW-HD880 - Manual (Page 13)

HDMI Matrix Switcher
13
[x1]
B[x2],[x3],[x4].
Transfer both the video and the audio signals from the input channel
[x1] to the output channels [x2], [x3] and [x4].
[x1]P[g]. Transfer both the video and the audio signals from the input channel
[x1] to the output group [g].
[g]PP[x2],[x3],[x
4].
Together the output channels [x2], [x3] and [x4] to the output group
[g].
S[g]. Inquire the output channels of output group [g].
Status[x1]. Inquire the input channel to the output channel [x1].
Status. Inquire the input channel to the output channels one by one.
Save[Y]. Save the present operation to the preset command [Y]. [Y] ranges
from 0 to 9.
Recall[Y]. Recall the preset command [Y].
Clear[Y]. Clear the preset command [Y].
Remarks: Dot is one part of the RS232 code!
Note:
1. [x1], [x2], [x3] and [x4] are the symbols of input or output channels ranged according to the
model of the matrix switcher. If the symbols exceed the effective range, it would be taken as a
wrong command.
2. In above commands, “[”and “]” are symbols for easy reading and do not need to be typed in
actual operation.
3. Please remember to end the commands with the ending symbols “.” and “;”.
Detail Examples:
1
、 Transfer signals from an input channel to all output channels: [x1]All.
Example: To transfer signals from the input channel No.3 to all output channels. Run Command:
“3All.”
2
、 Transfer all input signals to the corresponding output channels respectively: All#.
Example: If this command is carried out, the status of it will be: 1->1, 2->2, 3->3, 4->4……16->16.
3
、 Switch off all the output channels: All$.
Example: After running this command, there will be no signals on all the output channels.
4
、 Check the version of the firmware:
/^Version;
To check the version of the firmware.
5
、 Switch off the detail feedback command from the COM port: /:MessageOff;
Switch off the detail feedback information from the COM port. But, it will leave the “switch OK” as
the feedback, when you switch the matrix.
6
、 Switch on the detail feedback command from the COM port: /:MessageOn;
Switch on the detail feedback information from the COM port. it will show the detail switch
information when it switch. Example: when switch 1->2 for Audio, it will feedback “A0102”.
7
、 Transfer signals from an input channel to the corresponding output channel: [x]#.
Example: To transfer signals from the input channel No.5 to the output channel No.5. Run
Command: “5#.”
8
、Switch off an output channel: [x]$.
Example: To switch off the output channel No.5. Run Command: “5$.”