CONTREX CX-1200 - Manual (Page 12)

Page 10
Step 1 - Freq In 2 & CO Setup - Parameter Entry
Go to System Setup Freq In\Page 1.
Configure the CP’s on this screen as required.
State {MP-50}
Cnt Mode FI2 {CP-265}
PPR FI2 {CP-266}
CO Mode {CP-270}
CO Max Volts {CP-271}
Sync Mode {CP-203}
NOTE: The Help key accesses the Help screen and gives you a brief description of the parameter or subject
that is highlighted (active) on the screen. Press the Help key again to return to the previous screen.
NOTE: Sync Mode {CP-203} MUST have OFF selected. If the CX-1200 is not at factory default, then reference
the Operator Interface Primer, Kepad Operation,Code Select key and change Sync Mode {CP-203}.
Press the "Page Down" key to proceed to the next page.
Step 2 - Motor/Encoder Signal Polarity Setup - Parameter Entry
The CX-1200 will display System Setup Signal Polarity\Page 2.
Configure the CP’s on this screen as required.
State {MP-50}
RUN Mode {CP-202}
Direct SPx {CP-201}
CO Polarity {CP-272}
CO Offset {CP-273}
CO Volts {MP-37}
FI2 Hz {MP-03}
NOTE: The Help key accesses the Help screen and gives you a brief description of the parameter or subject
that is highlighted (active) on the screen. Press the Help key again to return to the previous screen.