CTI Products TurboVUi Solo Client Software - Manual (Page 5)

TurboVUi Solo Software Installation and Configuration Guide
5
R
UN THE
T
URBO
VU
I
S
OLO
C
LIENT
Did you connect a microphone yet? If not, go to the previous section Connect a Microphone.
1. Double-click the TurboVUi Client icon on the desktop.
2. The Connect window will be displayed as shown to the right.
a. Use the TurboVUi Gateway field to enter the IP Address of the
TurboVUi IP Gateway. If TurboVUi Solo Clients will be placed
outside your organization’s Local Area Network, the IT Administrator
must configure port forwarding within the firewall or router connecting
the TurboVUi IP Gateway module to the ISP (Internet Service
Provider). Since the connection must pass through a firewall with a
port forwarding rule, the IP address parameter must be entered using
the following format:
aaa.bbb.ccc.ddd:ppppp
where aaa, bbb, ccc, and ddd are the four octets of the firewall IP address, and ppppp is the port
number. The following example would be used to connect to the demo TurboVUi IP Gateway at CTI:
216.228.66.251:48222
Since 48222 is the default port number used by TurboVUi IP Gateways and TurboVUi clients, the port
number is not necessary in the example above.
An alias name can be created for the IP address and port number specified above by clicking the Settings
button on the above window, and then choosing the Network Aliases tab.
b. For Username, use “admin”.
c. For Password, use “admin”. (This password can be changed: from the Settings menu; click Gateway,
then the Accounts tab, then select the Admin account.)
3. Click the Connect button. The Status Bar at the bottom of the TurboVUi Solo client will indicate the User ID, as
well as the connection status of the Gateway and the Radio as indicated below .