Controlled Products Systems Group DTEK110VAC - Manual (Page 5)

Technical Specifications
Power: the detector is available in the following voltages, 12V AC/DC, 24V AC, 24V DC, 110V
AC, 220V AC. maximum current draw 100mA.
Low power detector is available with maximum current draw of 60mA
Temperature: -40F to + 180F
Environmental Protection: Circuit board is conformally coated
Enclosure:
Extruded anodized aluminum, Height = 3.25 inches 83 mm
Width = 2.56 inches 40 mm
Depth = 3.65 inches 90 mm
Output Relays: 5A/125 V AC standard version, 1A/125 V AC low current version
Connector: 86CP11 compatible with 11pin Octal DIN rail mountable socket or
wire harness
Surge Protection: The detector is protected with neon discharge lamps, Zener diodes
and surge arrestors.
Loop Input: Transformer isolated
Grounded Loop: The loop isolation transformer allows operation with poor quality
loops.
Loop Inductance Range: 20 to 2000 micro henries with Q factor of 5 or higher.
Tuning: Detector automatically tunes to the loop after power application or
reset.
Tracking: Detector automatically tracks and compensates for environmental
changes
Power Indicator: Green LED solid light indicates power
Loop Failure Indicator: Green LED blinks indicates loop problem
Loop Failure Memory: Green LED blinks with fast consecutive blinks indicates past loop
problem that healed.
Detect Indicator: Red LED solid light indicates detection
Extend Indicator: Red LED blinks after a car left the loop indicates time extend
feature
Sensitivity: is set by 10 position rotary switch
Frequency: is set three position toggle switch
Infinite Presence Mode: DIP switch selectable presence
Limited 4 Minutes
Presence Time:
DIP switch selectable
Second Presence Relay: DIP switch selectable
Pulse On Exit / Entry: DIP switch selectable
Fail Safe / Secure : DIP switch selectable
Filter: DIP switch selectable 2 seconds
Extended Detection: DIP switch selectable 3, 6 and 9 seconds
DTEK.lwp Created: March 23, 1998 Revised: January 16, 2003 10:44AM Pages:5 Page:5