Impulse 520W User Manual
Page 47
Configuring a Wireless Module (Continued)
Start the Ethernet Config utility (Start Æ All Programs Æ Sealevel SeaMAX Æ
Ethernet Config) installed with SeaMAX. In the ‘Available SeaI/O Devices’ pane,
you should see a “SeaIO Wireless” module listed under Model, as shown below.
If the module doesn’t show up, click the “Search for SeaI/O Devices” button. The
‘Available SeaI/O Devices’ pane should refresh with any Ethernet or Wireless SeaI/O
modules that are found on the network.
At this point, since no DHCP server is available, the wireless SeaI/O module will
default to a random IP address in the range 192.168.0.x.
Notice that the ‘Name’ is not displayed due to the wireless SeaI/O module residing
on a different subnet than your wireless adapter. Ethernet Config will mask the
‘Name’ of SeaI/O modules operating on a different subnet than the subnet you are
currently using.
Take note of the IP Address of the wireless SeaI/O module listed in the ‘Available
SeaI/O Devices’ pane. You will need this number in order to continue.
Also, make sure that the MAC Address shown matches the MAC Address on the
label on the bottom of the wireless SeaI/O module. If the MAC address doesn’t
match, contact technical support for further assistance.
Close Ethernet Config before continuing.
© Sealevel Systems, Inc.
- 44 -
SeaI/O User Manual