Lectrosonics R400 - Manual (Page 8)

R400
R400 MENU SELECTIONS
Main Window
R400 557.100
C3 NORM 1000
100
10
1uV
P
40 20 0
R400 Menu Map
TopMenu SetUpRx
LockSet
Scan
xExit
SetUpRx
LockSet
Scan
SmrtTun*
SmrtTun
Return to
Main Window
BACK
LockSet
NOT LOCKED
Freq Scan
Window
Coarse
Scan Scroll
SmartTuning
in progress...
Fine
Scan Scroll
TxBatt
SmartNR
Tone
+00 dBu
PilotBP
NORMAL
Phase
NORMAL
TxBatt
9V LTH
0.0V
SmartNR
NORMAL
Normal
Fact Grp A
Tuning
Tuning
Tuning
Tuning
Tuning
Tuning
Fact Grp B
Fact Grp D
User Grp U
Fact Grp C
Tuning
User Grp V
Compat
Compat
Compat
400 Series
Compat
Compat
IFB*
200 Series
100 Series
MODE 3
Exit
*Firmware Version 1.5 and above
Return to Top Menu
Level
Freq
Level
+00 dBu
Freq TV28
C3
557.100 MHz
NORMAL
Tuning
Compat
Tone
PilotBP
Phase
MAIN WINDOW DISPLAY
Icon Description
P Pilot tone indicator - A steady “P” is displayed when the transmitter pilot tone is present (200 Series
and the native 400 Series Compatibility Modes only). The icon flashes if no pilot tone is detected and
changes to a small “b” if the pilot tone has been bypassed. To bypass the pilot tone, from the Main
Window, push the MENU control twice to select SetUpRx, then rotate the control to select PilotBP.
Push the MENU control again and rotate it to highlight BYPASS. Push the POWER/PREV MENU
button several times to return to the Main Window.
Antenna Phase indicator - Displays antenna phase switching activity. As the DIV ANT phase is
switched, the symbol will flip vertically.
RF level - Displays the relative strength of the incoming RF. The icon grows taller as the strength of
the incoming RF signal increases. RF level calibrations are shown from 1 uV to 1000uV on the bezel
to the left of the RF level icon.
Audio Level - The audio level bar changes in size horizontally to indicate the audio level (modula­
40 20 0
tion) of the signal received from the transmitter. The bar display will show a vertical bar at the right
end when the audio signal is in limiting (maximum level) at the transmitter. Calibration marks in dB
are displayed below the bar.
Battery Level - Indicates the transmitter battery status or the transmitter battery use time, depending
on the TXBAT setting. The transmitter battery status icon is available only in compatibility modes
supporting battery telemetry (400 and 200 Series). In such cases, the transmitter battery status icon
appears 5 to 10 seconds after the transmitter signal is acquired. If selected in the TXBAT setup
screen, the transmitter battery timer is available in any compatibility mode. It accumulates hours and
minutes that the communications link is active, retaining the timing even when the receiver is off.
557.100
Operating Frequency/Tuning Mode/Switch Settings - Displays the operating frequency, the tuning
C3 NORM mode and the settings for the Frequency Select Switches in the associated transmitter(s). The
Tuning Mode indicates whether the receiver is set for Normal tuning or Group tuning. (See Tuning
Menu)
8