Lectrosonics UCR511 - Manual (Page 10)

UCR511
MENU SELECTIONS FROM MAIN WINDOW
Main Window
Frequency
Scan Mode
SELECT
Lock/Unlock
TX 7.2V
RX 8.2V
Pilot Off/On
Battery Level
Window
Frequency
Window
P
re
ss
M
ENU
P
re
s s
M
EN
U
Press
M
E
N
U
Pres
s
M
E
N
U
Hold MENU & press UP
Press All Buttons
Press & Hold MENU
SETUP
EXIT
LEVEL
00 dBu
SETUP
LEVEL
SETUP
TONE
TONE?
00 dBu
LVL 1K
SETUP
TX BAT
00 dBu
Press UP
Press
UP
Press UP
Press MENU
Setup Window
(Press UP / DOWN to adjust)
Level
Audio Test Tone
TXBAT
9V ALK
Press MENU
(Press UP / DOWN to adjust)
Press MENU
Press MENU
Audio Test Tone
(Press UP / DOWN to select)
Tx Battery Type
PHASE
INVERT
Press MENU
(Press UP / DOWN to select)
Output Phase
SETUP
PHASE
SETUP
SmtNR
Press
UP
Press MENU SmtNR
NORMAL
(Press UP / DOWN to select)
Press MENU
P
re
ss UP
Noise Reduction
SETUP
TUNING
Press
UP
Press MENU TUNING
NORMAL
(Press UP / DOWN to select)
Press MENU
Tuning Mode
SETUP
COMPAT
Press
UP
Press MENU COMPAT
500
(Press UP / DOWN to select)
Press MENU
Compatibility Mode
Press
UP
Press MENU
Press
MENU
Press
MENU
Press
UP
TV41 AE
631.800
From the Main Window, you can navigate to the Fre­
quency, Battery Level and Setup windows in a circular
sequence by pressing the MENU button.
FREQUENCY WINDOW
TVxx - which television broadcast
channel this frequency falls within.
Transmitter switch settings (AE in
the illustration) - these are the
correct switch settings for the frequency switches on
your transmitter - see your transmitter instructions.
TV41 AE
631.800
Frequency - Press the SEL Up or Down buttons to
change the frequency of the receiver.
Note
Be certain to change the transmitter frequency select switches to
match the settings shown in the upper right hand corner of the
Frequency Window display.
When the TUNING mode is set to NORMAL, the SEL Up
or Down buttons tune in single channel increments. In
the group tuning modes, the UP and DOWN buttons
move among the selected intermod-free frequencies.
Tuning short-cuts: In NORMAL tuning mode, MENU+Up
and MENU+Down tune in 16 channel increments for
faster tuning. In the group tuning modes, MENU+Up
jumps to the first frequency in the group and
MENU+Down jumps to the last one in the group.
BATTERY LEVEL WINDOW
This window shows the transmitter (TX)
and receiver (RX) battery voltage.
These levels will flash when the
voltages drop below suggested opti­
mum working levels. Typically, there
will be about one hour operating time remaining after the
indicators begin to flash. The RX voltage changes to EX
when operating on external power and displays the
external power source voltage. (
Disclaimer: We don’t
guarantee 0.1 Volt accuracy.)
TX 7.2V
RX 8.2V
SETUP WINDOW
In the SETUP window, the SEL Up
or Down buttons scroll through a list
of eight possible destinations: EXIT,
SETUP
EXIT
10