Lectrosonics UCR511 User Manual
Page 16
UCR511
Scan
B8
Vertical marker moves left to right
1000
100
10
1
uV
RF activity
Strength of RF activity is
indicated in microvolts with
markings on the front panel
display from left to right. RF activity will be
indicated by dark areas in the display.
5. RF signal strength is indicated by markings in
microvolts on the front panel to the left of the
LCD. Look for clear channels in the spectrum
Scan
1000
100
10
1
uV
No RF activity (clear channel)
B8
where there is no RF activity. Scanning will
repeat and continue until a button is pressed.
B8
Fine adjustment can be made when zoomed closer
.
6. If necessary, press the MENU button to zoom
in for greater detail for fine adjustment.
8. Then press the SEL Up and Down arrows to
move the marker to the middle of a clear area
1000
100
10
1
uV
Move marker to area with no RF activity
B8
where there is no RF activity. If an area with
no RF activity cannot be found anywhere in
the spectrum, locate one with the least
amount of RF activity.
9. Press all three buttons (SEL Up and Down
and MENU) to move to the next screen. Two
options will be shown.
Press the SEL Down arrow button to
select the USE NEW option and set the
receiver to the new frequency just found
in scanning.
Press the SEL Up arrow button to select
USE OLD and return to the frequency
that was set before scanning.
LOCKING AND UNLOCKING THE UCR511
FRONT PANEL CONTROLS
Pilot
Div RF
Aud Rx Tx
BAT
-40 -20 0 dB
1000
100
10
1
uV
OFF
ON
MENU
SEL
1
2
LECTRO
Use the SEL Up and Down arrow buttons to select the old
or new frequency.
The front panel panel controls can be “LOCKED” to
prevent accidental changes being made during operation
and handling.
To LOCK the UCR511 - Press and hold the MENU
button until a bar tracks horizontally across the LCD
screen and the word “LOCKED” appears. If the MENU
button is released before the word “LOCKED” appears,
the unit will remain UNLOCKED. When in a LOCKED
state, the pilot tone bypass toggle is also defeated.
In LOCKED state, the use of the MENU and SEL Up/
Down buttons are limited to “view only” and any attempts
to change selections will result in a LCD screen display
ing the word “LOCKED.” The unit cannot be used for RF
scanning when it is set in the LOCKED state.
To UNLOCK the UCR511 - Press and hold the MENU
button until a bar tracks horizontally across the screen
and the word “UNLOCKED” is displayed on the LCD
screen. When the unit is UNLOCKED, all settings can be
altered.
The UCR511 can only be LOCKED or UNLOCKED from
any of the main windows. (There are four of them.)
Also, it cannot be switched between LOCKED and
UNLOCKED modes when it is in a scanning mode or
from other subordinate screens.
16