Lectrosonics Quadra - Manual (Page 15)

Digital IEM System
Factory Defaults
This is used if you intend to reset the receiver back to
factory settings. Select Defaults on the main menu
and press MENU/SEL to select the two choices.
Default Setup restores the factory settings, but leaves
User Presets intact. Factory Wipe restores the factory
settings and deletes the stored User Presets.
Factory Default Settings:
• 4 Channel operation
• M (1,2)+3+4 knob setup
• RF Frequency 1 (907.776 MHz)
• Limiter at 0 dB threshold
• Pre-Gain at +0 dB
• Backlight: off at 5 minutes
• Treble Shelf: 5 kHz corner, +0 dB
• Unlocked
After using the MENU/SEL to select the appropriate
default operation, press MENU/SEL to continue the
operation. You will be asked to confirm this step - you
must use the arrow keys to select Yes, followed by
pressing the MENU/SEL once again. Defaults Re­
stored or Factory Initialized will be briefly shown on
the LCD, depending on which version of the default
operation was chosen. This indicates the process is
complete. If you have selected “Factory Wipe”, the
receiver will also re-boot and return to the main operat­
ing screen.
Using the Presets
Presets can be used to store all user settings includ­
ing Channel Setup, knob configuration, panning, and
operating frequency. Five factory presets give you the
most common starting configurations, while eight user
presets allow you to customize your receiver and store
those detailed settings. This may be particularly useful
for monitor engineers who may wish to have a “copy”
of each musician’s settings in their own receiver pack.
Select
Presets in the main menu and press MENU/
SEL to enter the submenu.
Four menu items are available in the sub-menu to
save, retrieve and delete stored settings: Load, Save,
Clear and None.
Load
To retrieve a factory preset or a previously saved user
preset, use the arrow buttons to select Load. Press the
MENU/SEL button to select this function.
The current Preset will be displayed
here. If no Preset is in use, the
character will be replaced by a
double dash symbol ( – – ).
Once in the Load from screen, use the UP and
DOWN arrow buttons to select from the five Factory
Presets and the eight User Presets. Unused preset
slots will be indicated as (empty).
Rio Rancho, NM 15