Lectrosonics Quadra - Manual (Page 22)

QUADRA
3. Insert the adapter plate (the one with threaded
Rack Mount Hardware
nuts) into the slot behind the front panel. Insert two
The M4T is delivered with a partial set of rack mount
hardware, including bolts, a rack ear, connecting
flanges, antenna cable and front-panel handles. With
two M4T units, there is enough hardware supplied to
connect the two units together, front-mount the anten­
nas, and prepare the units as a complete assembly
ready for mounting in a rack enclosure.
If you need to rack-mount a single M4T transmitter,
you will need to purchase the optional RMPM4T-1
rack kit. The kit provides a blank half-rack panel, a rear
mounting brace and the additional hardware required
for this setup (see page 24).
Dual Unit Rack-Mount
Instructions
1. Remove the plastic end-caps from the front of the
M4T and pry out the metal inserts on each side of
the transmitters with a small screwdriver.
Plastic guards snap out
from corners. Pry out the
aluminum inserts on the
side panel with a small
screwdriver.
2. Insert the rack ears and attach the handle to the
front panels using the supplied hex-head bolts and
hex wrench. The screws should go through the
handles, through the front panel, and into the rack
ear nuts. Tighten these bolts loosely.
Attach the antenna cables to the rack ears with
the supplied nuts and lock washers. Tighten with
a small wrench - do not over-tighten the nuts but
make sure they are snug enough not to work
loose.
of the hex head screws through the panel and into
the threaded nuts, but do not fully tighten them yet.
NOTE: The threads in the front adapter plate are
a self-locking type, so they will feel snug through
the entire length of the threads.
4. Attach the two front panels and insert the hex
head screws, but do not fully tighten them yet.
5. Remove the hex head screws from the rear of both
units where the housings contact each other. At­
tach the two units using the adapter plate (not the
one with threaded nuts) and secure them with the
supplied hex head screws.
6. Tighten all of the hex head screws that were just
installed on the front and rear panels.
LECTROSONICS, INC. 22