Lectrosonics DMTH4 - Manual (Page 11)

Installation Guide
Rio Rancho, NM 11
Installing LecNet2 ™ Software and USB Driver
The LecNet2 USB drivers are installed from the Installa-
tion Disk which comes with each processor by running
the LecNet2 Device Installer. Normally, this is done
before connecting a processor for the first time, how-
ever, it can done afterwards if necessary. The driver
installation only needs to be done once.
If a LecNet device is connected to a PC without prior
installation of the driver from the Installation Disk,
manual installation is possible in the cases of Windows
XP and Vista operating systems using the New Hard-
ware Found wizard. In the case of Windows 7, there is
no New Hardware Found wizard, so manual installation
is a bit more involved. In any of these cases, it’s not
really necessary - just cancel the New Hardware Found
wizard (if open) and run the LecNet2 Device Installer
from the Installation Disk.
Installation with LecNet2 Device Installer
Step 1
Place the LecNet2 Installation Disk into the CD-ROM
drive on the computer. If Auto Run is enabled on that
drive, the installation utility will open.
If AutoRun is not enabled, use Start>Run to run auto-
Run.exe on the drive holding the LecNet2 Installation
Disk.
If the CD-ROM drive is assigned as drive E: then type
E:\autoRun.exe in the window and press Enter to open
the LecNet2 utility.
With Windows Vista and 7 operating systems, click on
the Windows logo at the bottom left of the desktop, then
type E:\autoRun.exe into the search field just above
the Windows logo.
Two versions of the USB driver installer are provided for
different types of Windows PC:
• 32-bit Windows, click on Install USB Drivers (32-bit)
• 63-bit Windows, click on Install USB Drivers (64-bit)
Click on the option that is correct for your PC.
Step 2
The LecNet2 Device Installer opens:
Click Next to proceed
Step 3
The EULA is presented: