Lectrosonics LE Series - Manual (Page 9)

NOTE: To restore the original factory settings, hold down the NOTCH FILTER 3 and STORE SETTING
buttons while turning on the MAIN POWER SWITCH on the AC1, EC1, or SC1. The EQ and NF LEDs will
blink. Now turn the MAIN POWER SWITCH off, release the buttons, and turn the MAIN POWER switch back
on. Memory is now reset to original factory settings.
7) Using the PRIORITY/AUTO/DIRECT switch on the AP4 or EP4, switch the current microphone to AUTO, and the
next microphone to be adjusted to DIRECT. Repeat steps 5 and 6.
8) When all system microphones have been adjusted, reset the THRESHOLD control on the AC1 Main module to
the position it was in before this adjustment procedure, and restore the system to proper level using the MAIN
LEVEL control on the AC1. Return all PRIORITY/AUTO/DIRECT switches on the EP4(s) to the AUTO position.
Set the OPERATE/NEW SETTING switch on the LE8 to OPERATE, and be sure that the ACTIVE/BYPASS switch
is in ACTIVE. This completes the setup procedure for the LE8.
MULTIPLE LE8 SETUP
Set all mic preamp channels to "auto." Rotate THRESHOLD control on the AC1 system controller fully clockwise
(max) to keep channels off, other than the one that is being adjusted. Set all LE8 switches to "active" and
"operate."
Set up sequence:
1) Set ACTIVE/BYPASS switch on first LE8 to "active." Set OPERATE/NEW SETTING switch to "new setting."
Set desired channel to "direct" on the microphone preamp module. Verify that the CH ON LED on the desired
mic preamp channel is the only one turned on. Verify that the corresponding ACTIVE LOGIC INPUT LED on the
LE8 is also lit.
2) Select the desired EQUALIZER switch (treble, mid bass, etc.) and adjust the boost/cut as needed. Press the
STORE SETTING switch at each step once the desired adjustment is achieved. The filter function LED will blink
once to verify storage of the setting.
NOTE: It is necessary to press the STORE SETTING switch at each step of the adjustment process.
For example: TREBLE adjust > STORE
MID TREBLE adjust > STORE
MID BASS adjust > STORE
NOTCH FILTER 1 adjust > STORE
etc.
3) When the adjustments are completed for the first mic channel, set the mic preamp channel back to the "auto"
mode, and proceed to the next mic channel by setting it to "direct." Again, verify that the LEDs indicate as
described in step 1 above.
4) Once all adjustments have been made and stored for all logic inputs being used on the first module, set the
OPERATE/NEW SETTING switch to "operate" and the ACTIVE/BYPASS switch to "bypass."
5) Proceed to the next LE8 in the "chain." Go through steps 1 through 4 as listed above.
8