Liquid Controls IT275N - Manual (Page 5)

Sponsler, Inc. IT275N Remote Totalizer & Rate Indicator pg. 5 DOC#: MN-275N-A
INSTALLATION
Inspection
All units are completely assembled, inspected and tested at the factory prior to shipment. Upon receipt
of the unit, a visual inspection should be conducted to detect any impropriety or damage that may have
occurred during shipment. Report any discrepancy to the factory immediately.
Physical
The IT275N Remote Totalizer & Rate Indicator is meter mounted and should be positioned as practically
as possible taking into account display visibility, accessibility, etc. The IT275N enclosure is rated Class I
Groups B,C,D; Class II Groups E,F,G; and Class III Nema 4 and will withstand the harshest
environment.
Electrical
The IT275N Remote Totalizer & Rate Indicator is designed to operate with a single internal AA battery
and requires no external wiring for power. Wiring of the analog output can be accomplished in a couple
of different methods to fit the application. For the analog output, shielded cable is not required.
Signal
A 2 wire twisted pair with molex and tinned terminations is standard. Pin orientation of the molex
connector or the tinned terminations is negligible.
FIGURE 1