Lightronics TL2448 - Manual (Page 16)

Page 16 of 18
TL - 2448 LIGHTING CONTROLLER
Version 0.6
OWNERS MANUAL
12/27/2007
www.lightronics.com
Lightronics Inc. 509 Central Drive Virginia Beach, VA 23454 757 486 3588
OPERATION
A small pushbutton (Link Control Button) and a LED (Link Status Indicator) are located on the rear edge of the
console. The button controls all wireless operation. The LED indicates wireless status.
LINK STATUS INDICATOR LED
The indicator shows wireless status as follows:
OFF NO WIRELESS POWER
ON TRANSMITTER OK
FLASH LINKING IN PROGRESS or LINK RELEASE IN PROGRESS
LINK CONTROL BUTTON
This pushbutton switch is used to link all free receiver units within its range. It is also used to release the links
with all receivers in its range which are linked to it.
Links cannot not be made with receivers already linked to another transmitter unit.
You should begin by unlinking the receivers AT THE RECEIVERS you are going to use. They may be linked to
other transmitters. If this is the case then they cannot be linked or released by the TL-2448 you want to use until
they are released from the existing link.
LINKING RECEIVERS
Push the link control button once (do not hold down). The indicator LED will flash for about 10 seconds. It will
then go to an ON state.
The link indicator on the receiver will also flash and may continue this for several more seconds after the console
indicator goes back to ON. The link indicator on the receiver will go to an ON state when the link is stable.
RELEASING ALL RECEIVERS
This will release only receivers linked to the TL-2448 you are using.
Hold the link control button down for about 5 seconds.
The indicator LED will go to a flash state for about 10 seconds then return to ON. The link indicator on the
receiver unit(s) will go OFF
.
Link release for a single receiver unit can only be performed at the receiver unit. Performing this operation at the
receiver unit will release it from any/all transmitters.