Lightronics TL2448 - Manual (Page 4)

Page 4 of 18
TL - 2448 LIGHTING CONTROLLER
Version 0.6
OWNERS MANUAL
12/27/2007
www.lightronics.com
Lightronics Inc. 509 Central Drive Virginia Beach, VA 23454 757 486 3588
CONTROLS AND INDICATORS
X Faders
Controls intensity of channels 1 - 24
Y Faders
Controls intensity of channels 1 – 24. Controls intensity of channels 25 –
48 in 1 x 48 mode
SUBMASTERS Faders Activates prestored scenes.
HOUSE MASTER Fader
Console channel 99. Controls any dimmer channel assigned to this
number. The fader acts independently of all other console functions
including the GRAND MASTER fader.
GRAND MASTER Fader
Master override control for all channels and scenes. Does not affect
HOUSE MASTER or chase levels.
X and Y Cross Fader Pair Transfers control between upper and lower channel faders.
MOMENTARY INTENSITY Fader Controls the intensity level of the momentary (bump) buttons.
CUE MASTER Fader Controls the overall intensity of scenes activated via the cue list.
Chase FADE Fader Controls the rate at which chase steps fade in and out.
Chase INTENSITY Fader Controls the intensity of the chase patterns.
Momentary (BUMP) Buttons Activates the associated channel while depressed.
Submaster Momentary Buttons Activates the associated scene while depressed.
1 x 48 MODE Button and Indicator Controls whether lower (Y) faders will act as channels 1- 24 or 25 – 48.
SOLO Button and Indicator
Causes bump button to blackout all channels except the channel
associated with the button pushed.
BLACKOUT Button and Indicator Turns off all channels, scenes and chase patterns.
RECORD Button and Indicator Used to save scenes, chases, and cues into the TL-2448 memory.
GO Button Causes Cue to advance to the next scene in the list.
TAP Button Controls the chase step rate.
SUBMASTER BANK Button Used to set the current scene bank.
MOVING LIGHT SCENES Button
and Indicator
Activates moving light scenes.
PRGM MOVING LIGHTS Button
and Indicator
Controls moving light set up.
CHASE SELECT Button and LED Enables submaster momentary buttons as chase 1 – 12 selection.
Keypad Buttons Used to enter various patch, chase, and cue list selections.
(Left Arrow) Used with menu system.
MENU Activates menu system and executes menu selections.
(Right Arrow ) Used with menu system. Also selects current patch page.
Number Keys Used to enter and edit various setup parameters.
(DIMMER / CHASE) Used with keypad to enter various parameters.
# (ASSIGN / NEXT CUE)
Used to enter various parameters.
LCD Display
Shows status of various functions and is used with the menu system to set
the parameters of the console operation.
POWER Indicator Indicates unit is on and flashes at the current chase rate.
WORK LIGHT Connector Used for a 12vdc lamp.