Magnum Venus Plastech UltraMAX MVP Installation & Set-Up - Manual (Page 2)

h. Attach the ground wire from the gun to the electrical grounding lug on the pump mounting
bracket.
Note:
Check electrical ground to ensure it is installed from the pump mounting bracket to an
earth ground.
i. Remove the catalyst poly tubes from the component box.
j. Cut the ½ inch diameter poly line, with the clamps, to 26 inches long. Clamp one end to the
outlet of the catalyst jug and the other end to the inlet of the catalyst pump. Make sure clamps
are airtight.
k. Connect the ¼-inch poly line to the relief valve on the catalyst manifold assembly and insert
the other end into the hole in the top of the catalyst jug.
l. Connect the ¼-inch poly line to the catalyst recirculation valve on the catalyst manifold, and
insert the other end into the hole in the top of the catalyst jug.
9.
Check all components for damage.
Corporate Headquarters/Manufacturing
5148 113
th
Ave.
Clearwater, FL 33760 USA
Ph: (727) 573-2955
Fax: (727) 571-3636
MVP Technology Center
1862 Ives Ave.
Kent, WA 98032 USA
Ph: (253) 854-2660
Fax: (253) 854-1666
E-mail: [email protected] · Web: www.mvpind.com