Magnum Venus Plastech High Volume Pro Gun 60625-1 - Manual (Page 26)

High Volume Pro Gun Manual
Rev. 05/2012 Page | 26
RELIEF SPACER
CATALYST SEAL
PACKING RING
2. Insert the seal installation tool with the components on it, into the catalyst side of
the gun block. Press firmly, or tap with a rubber mallet, then pull the packing tool
out of the gun block.
Note: Again before inserting the seal installation tool, align the holes in the
catalyst seal with the holes in the gun block as closely as possible.
3. The catalyst components should be seated in the interior of the gun block against
the center spacer.
4. Gently screw a packing nut (58122-1) into the catalyst side. Do not tighten.
Align Catalyst Seal
1. Hold the catalyst alignment tool (6705-3-1) (tapered drill bit) firmly with a pair of pliers.
2. Insert the catalyst alignment tool (tapered end first) into the gun block through the
catalyst side on the rear of the gun block
3. Gently press and move the alignment tool around until the holes in the catalyst
seal aligns with the hole / port in the gun block.
Note: At this point, the catalyst side packing nut should only be hand tight.