Mallory Ignition ACCEL DIS 8 75610 - Manual (Page 8)

DIS 8
8
CAM/CRANK Mode Wiring Harness
In the Crank/Cam mode the DIS 8 receives a Crank (EST) and a Cam input. The DIS 8
then processes the input signals into 8 separate output signals. The signals are sent to
the negative side of the coils in the order set by the firing order in the handheld
controller. The crank position trigger / EST / Points Trigger signal is a rising edge (low–
to-high), and the cam position is a falling edge (high-to-low) transition.
NOTE CAM Sensor Must be a Hall Effect (12 volt square wave signal open
collector)
Coil Input Harness
PIN CHANNEL WIRE COLOR
A 1 Crank (EST) Input Purple
B 2 Cam Input Red/White
C Not Used Blue
D Not Used Green/White
E Switched Ignition Pink
F Not Used
G Not Used Green
H Not Used Blue/White
J Not Used Red
K Not Used Purple/White