Little Colorado Storage Cubby 64 - Manual (Page 3)

All of us at Little Colorado, Inc hope that you and your little ones enjoy this Storage Cubby for many years.
Please call us if you have any questions.
Manufactured in America by:
Little Colorado, Inc. 4450 Lipan Street Denver, Colorado 80211
Phone 303-964-3212 Fax 303-964-3213 [email protected]
Page 3 of 3
5. While the unit is still face down, slide the three Back panels into the 1/4" slots from the bottom all
the way in until they are completely seated into the 1/4" slot in the underside of the Top panel. Make
sure the pre-drilled holes through one side of the Back panels are toward the Bottom. Install two 5/8"
screws through the pre-drilled holes in the bottom of each back. It is important that each panel be
completely in the slots to ensure a snug fi t. These Back panels add a signifi cant amount of stability to
the Storage Cubby and must be installed properly.
6. Check to be sure that all pieces are completely fi tting into all slots. Install the remaining 1 1/4"
screws into the Left, Right, and Bottom panels. The two Vertical panels are attached to the underside
of the top using the two Angle Brackets with 1/2" screws.
A photo of this assembled product can be seen online at http://www.littlecolorado.com/stock64.html.
If you have questions about assembling this product, please call us and we will help you.
Back Panels Assembly View
Top
Inside Panels Assembly View
Top
Pre-Prilled holes for Angle
Brackets toward Top and facing
inside.
Long slots in Horizontal
panels face Bottom
5/8" Screws
Revised 07/10
N. Tommer