MAX HN65J - Manual (Page 7)

4. INSTRUCTIONS FOR OPERATION
Read section titled "SAFETY INSTRUCTIONS".
1. BEFORE OPERATION
X Wear Safety Glasses or Goggles.
Y Do not connect the air supply.
Z Inspect screw tightness.
[ Check operation of the contact arm & trigger if moving smoothly.
\ Connect the air supply.
] Check the air-leakage. (The Tool must not have the air-leakage.)
^ Hold the Tool with finger-off the trigger, then push the contact arm against the work-piece.
(The tool must not operate.)
_ Hold the Tool with contact arm free from work-piece and pull the trigger. (The Tool must
not operate.)
` Disconnect the air supply.
WARNING: 2. OPERATION
WEAR SAFETY GLASSES OR GOGGLES
Danger to the eyes always exists due to the possibility of dust being blown up by the
exhausted air or of a fastener flying up due to the improper handling of the tool. For these
reasons, safety glasses or goggles shall always be worn when operating the tool.
!
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 (Council Directive 89/686/EEC of 21 DEC. 1989) and provide both frontal and
side protection.
The employer is responsible to enforce the use of eye protection equipment by the tool
operator and all other personnel in the work area.
NOTE:
Non-side shielded spectacles and face shields alone do not provide adequate
protection.
In order to avoid a serious injury from ricocheting fasteners, shoot the nail into the hole of
metal hardware with the tool perpendicularly.
WARNING: !
Keep hands and body away from the discharge outlet when driving the fasteners because of
dangerous of hitting the hands or body by mistake.
WARNING: !
9