MAX GS865E - Manual (Page 13)

13
4. HOW TO USE THE BATTERY AND THE CHARGER
WARNING:
● Be sure to charge MAX JP606H for the tool with MAX JC610M. If charged with other charger,
the Battery could fail to be properly charged as well as get broken, ignited or generate the
heat.
● Do not put the Battery close to a fire.
● Do not leave the Battery in the direct sunshine.
● Do not charge or use the Battery in the wet condition with a liquid such as water, sea water,
milk, soft drink, soap water.
● Unplug the charger when it is not used.
● Be sure to charge at 0 to 40°C to avoid the possibility of fire.
● Do not give a strong shock such as hitting with a hammer, stamping or dropping.
WARNING:
● In order to prevent short-circuiting, be sure to cover the terminal block (metal section) of the
Battery with the Pack Cap (wind the insulating tape) for recycling.
<Battery cells in Battery Pack>
・ Nominal voltage: 1.2 V/piece
・ Quantity used in 1 pack: 5 pieces
CAUTION:
● When the Battery has been used up or is not used for a long period, remove it from the
Charger.
● After setting the Battery in the tool, do not hold it to carry around.
CAUTION:
● Do not use the out-of-life Battery.
Use of the out-of-life Battery leads to breakdown of the tool body, and charging it causes the
charger to go wrong.
PROPER USE OF BATTERY
q Fully charge and use up the Battery.
If you repeat charging the Battery while stored electricity still remains more than half the capacity, the
number of pins drivable by each charging could decrease dramatically, shortening the life of the
Battery. It is recommended to use it until the LED of the tool has been illuminated in red, indicating
that the Battery running out of electricity.
w Use two Batterys alternately.
To ensure the longer life of the Battery, it is recommended to use two of them alternately, one in use
while the other is charging preparing a spare one.
The Battery for the tool uses Ni-MH batteries which are a precious recyclable resource. Once the
Battery runs out of life, take it to your nearest distributor without disposing of it.
Recycling the Ni-MH Battery