Micromod Micro-DCI: 53SL5100B Single Loop Controller - Manual (Page 55)

53SL5100B Single-Loop Controller
INSTRUCTION MANUAL
49
6.3 Analog Backup Controller Parameter Selections
Figure 6-4 illustrates how an Analog Backup Controller would appear with only the default values and power
applied., but no analog input or output signals. In Figure 6-4, ANO0 (TB1-10) is jumpered to ANI0 (TB1-2) to
simulate process operation. The unit has the AC power supply and power cord 173D109U03.
Connecting ANO0 to ANI0 is done only for illustration purposes and is not necessary to configure the
controller. If the controller is connected to a Datalink network, then assign the Instrument Address (B001) and
Baud Rate (B002) first, so the remaining datapoints may be entered from the PC.
After this section, refer to Section 9, Parameter Display, to configure the parameter display datapoints. The
parameter display is accessed by pressing the F2 push button from this display. Also, refer to Section 10,
Instrument Tuning, or Section 11, EASY-TUNE, to set the operating performance parameters: Proportional
Band (C106), Reset Time (C107), and Rate Time (C108). All other datapoints not shown in the illustration are
at the default value.
Figure 6-4. CS2 Datapoint Selections