MIDLAND WR-120 Quick Guide - Manual

www.midlandradio.com
English
François
Español
WR-120 Owner’s Manual
External
Antenna
Antenna
Menu
Volume Up
Volume Down
Select
Power
Quick Start Instructions:
1. Place 3 AA alkaline batteries (not supplied) into the compartment on the
underside of radio.
(Note: Batteries provide approximately 5 hours of emergency power or 75
hours of standby power for the radio in case of a power outage).
2. Plug the AC Adapter into a standard outlet. Plug the other end of the
adapter into the DC jack on the back of the radio.
3. Pull out antenna and extend to its full length.
4. Ensure ON/OFF switch is in the ON position
5. WELCOME will be displayed.
6. To SET LANGUAGE press the
SELECT button then:
7. Choose your language by pressing
Ÿ
or
ź
then press the SELECT button.
8. To SET LOCATION press the SELECT button then:
9. Choose location type ANY then press SELECT .
(Note: see page 8 for more programming instructions).
10. To SET TIME press the SELECT button then:
11. Set the time by using
Ź Ÿ ź
or
Ź
then press SELECT .
12. To SET CHANNEL press the SELECT button then:
13. Tune the channel to the desired broadcast by using
Ÿ
or
ź
.
14. Adjust the volume by using the VOLUME UP or VOLUME DOWN button.
15. To complete setup press the SELECT button.
NOTE: To reset the radio to the factory defaults, press and hold the
WEATHER / SNOOZE button while turning on the unit.
To get the S.A.M.E. code in the USA: Call 1-888-697-7263 or go to
www.nws.noaa.gov/nwr/indexnw.htm
To get the CLC in Canada: Call 1-877-789-7733 or go to
www.ec.gc.ca/weatheradio
Directional Pad
ON/OFF
Switch