Multichannel Systems MPA32I Manual - Manual (Page 33)

Multi Channel Systems
MCS GmbH
Aspenhaustrasse 21
72770 Reutlingen
Germany Fon +49-7121-9 09 25- 0
Fax +49-7121-9 09 25-11
[email protected]
www.multichannelsystems.com
© 201 4 Multi Channel Systems MCS GmbH
Product information is subject to change without
notice.
:
ADPT-FM-72
FlexMEA adapter
for connecting two MPA32Is to the FlexMEA72
Drawer
Spacer
Contact pads of FlexMEA
Adapter with PBC
1. Please loosen the screws of the adapter that it is possible to move the bars of the ADPT-FM-72.
2. Open the withe drawers of the adapter by pre-drawing the black parts of the drawers
with the help of a forceps.
3. Connect the MPA32Is in correct manner, the bottom sides with screws must face outwards.
Please follow the instructions for mounting the the FlexMEA72 on the ADPT-FM-72 and the
MPA32Is step by step.
Necessary tools: A small Philipps head screwdriver
a sharp forceps
4. Insert the contact pads of the FlexMEA72 carefully with a forceps into the first drawer.
Insert the FlexMEA72 upside down, because the contact pads must have contact to the
printed circuit board of the ADPT-FM-72. Place the plastic spacer between contact pads
and drawer for a good contact between PCB and FlexMEA72. Please see the scheme.
The electrode part of the FlexMEA should face in direction of the ground connector.
Please handle the FlexMEA72 with great care!
5. Close the first drawer by pushing back the black part into the white part. The contact pad is fixed.
6. Insert the opposite contact pad of the FlexMEA72 into the second drawer,
place the plastic spacer between the back side of the FlexMEA and the
drawer and close it.
7. Thighten the screws of the ADPT-FM-72.
When connecting the FlexMEA72 and the adapter as shown on the picutre,
the electrodes of the FlexMEA72 face in the same direction as the MPA32Is.
The MPA32I on the right side is considered to be MPA32I No 1 with channels
No 1 to 32. The MPA32I on the left side of the FlexMEA is defined to be
MPA32I No 2 with channels 33 to 64.