Multichannel Systems MEAS42+MEASwitchUSB Manual - Manual (Page 8)

MEA S4/2 Manual
4
2.3 Important Safety Advice
Warning: Make sure to read the following advice prior to installations of the device. If you do
not fulfill all requirements stated below, this may lead to malfunctions, breakage, or even fatal
injuries. Obey always the rules of local regulations and laws. Only qualified personnel should be
allowed to perform laboratory work. Work according to good laboratory practice to obtain best
results and to minimize risks.
The product has been built to the state of the art and in accordance with recognized safety
engineering rules. The device may only
 be used for its intended purpose;
 be used when in a perfect condition.
Improper use could lead to serious, even fatal injuries to the user or third parties and damage
to the device itself or other material damage.
Malfunctions which could impair safety should be rectified immediately.
This device is no medical instrument and must not be used on humans.
High Voltage
 When connecting an external power supply, do not mismatch the polarity of the power supply.
A wrong connection may lead to fatal damage of the device.
 Use the lowest possible input supply voltage. Do not exceed the maximum input supply voltage
of 12 V. The higher the input supply voltage, the more heat is produced by the device.
 Electrical cords must be properly laid and installed. The length and quality of the cords must
be in accordance with local provisions.
 Only qualified technicians may work on the electrical system. It is essential that the accident
prevention regulations and those of the employers' liability associations are observed.
 Each time before starting up, make sure that the mains supply agrees with the specifications
of the product.
 Check the power cord for damage, each time the site is changed. Damaged power cords should
be replaced immediately and may never be reused.
 Check the leads for damage. Damaged leads should be replaced immediately and may never
be reused.
 Do not try to insert anything sharp or metallic into the case.
 Do not short-circuit the outputs of the device.
 Liquids may cause short circuits or other damage, even could lead to fatal injuries. Keep the device
and the power cords always dry. Do not handle it with wet hands. Make sure the device and your
experiment are set up in a way that makes it impossible that any liquid spills onto the device or
flows into the device from the surface of the table.
Requirements for the installation and during operation
 The device must be set up on a rigid, vibration-free base.
 The device produces heat and can get hot during operation.
 Do not touch the device during operation and do not store flammable materials nearby.
 Do not place anything on top of device, and do not place it on top of another heat producing
device.
 Do not open the case of the device.