DoorKing 1812 Classic - Manual (Page 32)

1812-065-U-12-13 30
2.6 Access Codes to Operate Access Control Devices
2.6.1 Access Code Programming
This programming sequence programs four-digit “Access Codes” into the system memory. The access codes will operate
either relay 1 or relay 2 with a specific function depending on the “location code”number that is choose from the table
below for every access code programmed. You can store up to 50 unique access codes into the system memory. We
recommend that you keep a log of all programmed access codes in the log sheet in back of this manual.
External time clock note (wired to terminal 6 and 9): When this input is activated, access codes that have been
programmed into the “Time Zone” location codes will not work (Refer to 1.11 and 4.14).
1. Press * 0 2 and enter the MASTER CODE. [ * 0 2 _ _ _ _ (beep)]
2. Enter the two-digit “location code” (See table below), then press * . [ _ _ * (beep)]
3. Choose and enter a four-digit access code, then press * . [ _ _ _ _ * (beep)]
4. Repeat steps 2 and 3 to enter additional access codes.
5. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
2.6.2 Delete an Access Code
This programming sequence deletes individual existing access codes that have been programmed into the system.
1. Press * 0 2 and enter the MASTER CODE. [ * 0 2 _ _ _ _ (beep)]
2. Enter the two-digit “location code” (See table above), then press * . [ _ _ * (beep)]
3. Enter # # # #, then press * . [ # # # # * (beep)]
4. Repeat steps 2 and 3 to delete additional existing access codes.
5. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
Each relay can have (See table below):
• 14 momentary activation codes - Relay will activate for its programmed relay strike time (2.3.4).
• 1 flash code - Flash code time zone must be programmed (2.4.6).
• 5 hold codes - Automatic relay activation time zone(s) must be programmed (2.4.3) and enabled (4.9).
• 5 time zone codes - Access code time zone(s) must be programmed (2.4.4)) and enabled (4.8).
1 - 14
15
16 - 20
21 - 25
Momentary Activation
Flash
Hold
Time Zone
26 - 39
40
41 - 45
46 - 50
Momentary Activation
Flash
Hold
Time Zone
Relay 1
Location Code (Step 2 ) Function
Relay 2
Location Code (Step 2) Function
2.6.3 Delete All Access Codes
This programming sequence deletes ALL existing access codes that have been programmed into the system.
WARNING: Once started, all access codes will be erased and cannot be retrieved.
1. Press * 0 0 and enter the MASTER CODE. [ * 0 0 _ _ _ _ (beep)]
2. Press 9 9 9 9, then press * . [ 9 9 9 9 * (beep)]
3. The programming sequence will end itself automatically. [beeeeeep]