DoorKing 1812 Access Plus - Manual (Page 40)

1812-162-M-1-12 38
2.6.8 Delete a “Temporary” Access Code
This programming sequence deletes individual existing “temporary” access codes that have been programmed into the
system. “simple” and/or “time zone restricted” access codes CANNOT be deleted. If you require “simple” and/or “time zone
restricted” access codes to be individually deleted, use the programming sequence in 2.6.5.
1. Press * 7 4 and enter the MASTER CODE. [ * 7 4 _ _ _ _ (beep)]
2. Enter the device type (0 = card, 1 = transmitter, 2 = keypad, 3 = other), then press * . [ _ * (beep)]
3. Enter the five-digit “temporary” access code to be deleted, then press * . [ _ _ _ _ _ * (beep)]
See 2.6.7 for the five-digit “temporary” access code(s).
4. Repeat steps 2 and 3 to delete additional existing “temporary” access codes.
5. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
2.6.7 “Temporary” Access Code Programming
This programming sequence programs up to 10 “temporary” access codes with a beginning and ending date and any time
zone restrictions and momentarily activate a relay or to hold open (latch) a relay that may need to be applied.
1. Press * 7 3 and enter the MASTER CODE. [ * 7 3 _ _ _ _ (beep)]
2. Enter the device type (0 = card, 1 = transmitter, 2 = keypad, 3 = other), then press * . [ _ * (beep)]
3. Choose and enter a five-digit “temporary” access code, then press * . [ _ _ _ _ _ * (beep)]
4. Enter the beginning month (01 to 12) and day (01 to 31), then press * . [ _ _ _ _ * (beep)]
5. Enter the ending month (01 to 12) and day (01 to 31), then press * . [ _ _ _ _ * (beep)]
6. Enter a minimum of 1, and a maximum of 4 time zones (valid time zones are 0 through 6) that you
want to apply to this access code, then press
* . [ _ _ _ _ * (beep)]
Time zone 0 - Always deny access.
Time zone 1 - Allows 24/7 access for relay 1 and any additional relays.
Time zone 2 - Allows 24/7 access for relay 2 and any additional relays.
Time zones 3, 4, 5 and 6 - Are time zones that have been programmed in 2.7.6.
7. Enter 0 * for momentary relay activation OR enter 1 * to hold (latch) the relay. [ _ * (beep)]
8. Repeat steps 2 through 7 to program additional “temporary” access codes.
9. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
2.6.9 Delete All “Temporary” Access Codes
1. Press * 7 5 and enter the MASTER CODE. [ * 7 5 _ _ _ _ (beep)]
2. Press 9 9 9 9, then press * . [ 9 9 9 9 (beep)]
3. The programming sequence will end itself automatically. [beeeeeep]
This programming sequence ONLY deletes ALL existing “temporary” access codes that have been programmed into the
system. “simple” and “time zone restricted” access codes CANNOT be deleted. If you require all “simple” and “time zone
restricted” access codes to be deleted, use the programming sequence in 2.6.6.
WARNING: Once started, all “temporary” access codes will be erased.