NetMedia iViewHD-2M - Manual (Page 10)

Quick Setup Procedure
This section presents a quick setup guide in configuring the iViewHD camera. For a more detailed
explanation, please consult the following sections of the manual
The iViewHD camera connects to a Power Over Ethernet (POE) network switch, such as the Netme-
dia POEmax or other suitable POE switch. The POE switch provides the network connectivity and
power for the camera.
To configure the iViewHD camera:
1. Plug in an Ethernet cable to the POE switch:
2. Plug the the other end of the Ethernet cable into the iViewHD Camera. The orange LED next to
the RJ45 connector should illuminate. The red LED in front of the camera will light up and the
camera should emit a series of beeps and you will probably see the green link activity light
blinking:
3. Connect a computer to the same network as the camera.
iViewHD Userʼs Manual
10 © 2009 NetMedia, Inc.