NetMedia iViewHD-2M - Manual (Page 39)

• 0 - Low
• 4 - Normal
• 8 - High
• SHARP: 0..7 Sharpness (default 0)
• 0 is Automatic sharpness
• 1..7 Progressively sharper images. Sharpness is based on edge detection and enhancement
• WB: 0..5 White balance (default 1)
• 0 - AWB Off
• 1 - AWB Automatic
• 2 - Sunny
• 3 - Cloudy
• 4 - Office
• 5 - Home
• DCW: Digital Crop Window. Defaults to size of current base resolution. This specifies an area of
the current image that is cropped before being displayed. You should begin by setting a base
resolution mode of either UXGA (1600x1200) or SVGA (800x600). The DCW operates on one of
these base resolutions and is relative to the Pan offset (see below).
• HxV - The horizontal and vertical size in pixels (separated by ʻxʼ) of the window within the
base resolution. This value should be in increments of 4 pixels - if not, it will be rounded
down to the nearest 4 pixels.
• PAN: Pan. Defaults to 0x0. This specifies a location to begin the DCW within the current base
resolution image.
• HxV - The horizontal and vertical location in pixels (separated by ʻxʼ). The coordinates are
relative to the upper left corner of the base resolution image. This value can be in increments
of 1 pixel.
• SIZE: Output image size. Defaults to size of current output resolution. This value should be no
larger than the DCW and the same image aspect ratio - if not, it will be adjusted automatically.
• HxV - The horizontal and vertical size in pixels (separated by ʻxʼ). This value should be in in-
crements of 4 pixels - if not, it will be rounded down to the nearest 4 pixels.
• VFLIP: Vertical flip (default 1) †
• 0 - Do not flip image vertically
• 1 - Flip image vertically
• HMIRROR: Horizontal mirror (default 1) †
• 0 - Do not mirror image horizontally
• 1 - Mirror image horizontally
Some examples of HTTP commands using the COMMAND= option are
/image.cgi?CAPTURE=YES&STREAM=1&COMMAND=MODE:UXGA,COMP:25
Starts receive MJPEG images at UXGA resolution with compression level 25
/image.cgi?CAPTURE=YES&STREAM=1&COMMAND=MODE:UXGA,COMP:25,VFLIP:0,HMIRROR:0
Receives UXGA MJPEG images at compression level 25 and images are inverted. This is useful if
the camera is mounted upside down.
iViewHD Userʼs Manual
© 2009 NetMedia, Inc. 39
† The sensor is mounted upside down in the camera and thus the image is normally vertically flipped and horizontally mir-
rored to appear correct