Nitek FSS20811S - Manual (Page 3)

Troubleshooting
Problem: No video present
1. Is the Power LED in the device illuminated?
Answer — No
 Check to insure power adapter is properly connected to the device
and power outlet.
 Is the correct 5V DC adaptor that was supplied with the unit being
used?
 Contact tech support at Nitek
2. Is the LED for fiber connection in the device FLASH?
Answer — Yes
 Check the fiber connection to both transmitter and receiver.
 Check the SC fiber connector on both transmitter and receiver is clean and properly connected to the fiber cable.
 Contact tech support at Nitek
3. Is the LED for video connection in the device illuminated?
Answer — No
 Check the camera for a video output.
 Check the video cable connection between the camera and the transmitter and also the monitor and the receiver.
 Check the BNC connector on both transmitter and receiver is clean and properly connected to the video cable.
 Contact tech support at Nitek
LED INDICATORS
LED STATUS
PWR
On - Normal Operation, unit powered-up
Off - Check power supply
VIDEO * Glows - With Video Luminance
Tx Blinks - Normal when data is transmitted
Rx
On - No Fiber Connection
Blinks - Normal when data is received
* Receiver Blinks rapidly with NO Fiber Connection
Common Installation for an
8 Channel Configuration