Control Company 4410 DEW-POINT/WET-BULB/HUMIDITY/TEMPERATURE ALARM - Manual (Page 2)

© 2005 Control Company. 92-4410-00 Rev. 0 050306
Traceable ® is a registered trademark of Control Company.
TRACEABLE
DEW-POINT/
WET-BULB/
HUMIDITY/
TEMPERATURE
ALARM
INSTRUCTIONS
®
aUto SHUt-off featURe
To preserve battery life, the unit may be set to
turn off automatically if no button is pressed for 20
minutes. No measurements are taken while the
unit is turned off; therefore, if alarms have been
set, they will not sound while the unit is off.
To enable the auto shut-off feature, press and hold
the CLEAR button until “AUTO OFF” appears on
the display. The unit will now turn off if no buttons
are pressed for 20 minutes. To turn the unit on,
press any button.
To disable the auto shut-off feature, press and hold
the CLEAR button until “AUTO OFF” no longer
appears on the display.
BencH StanD
The unit may be placed on a horizontal surface
by using the supplied plastic bench stand. Insert
the pegs of the bench stand into the holes located
on either side of the battery cover. The holes and
pegs are different sizes so that the stand may only
be inserted one way. Do not install the stand incor-
rectly and force it.
WaLL MoUntinG
Set a screw into the wall at the desired location.
Do not set the screw flush to the wall, the head of
the screw will need to slip into the receptacle on
the back of the unit. Once the screw has been
properly set, remove the bench stand (if installed),
and hang the unit in place by sliding the receptacle
on the back of the unit over the head of the screw.
aLL opeRationaL DifficULtieS
If this unit does not function properly for any
reason, replace the batteries with new high-quality
batteries (see “Battery Replacement” section). Low
battery power can occasionally cause any number
of “apparent” operational difficulties. Replacing the
batteries with new fresh batteries will solve most
difficulties.
BatteRY RepLaceMent
Erratic readings, a faint display, or no display are
all indications that the batteries must be replaced.
Remove the bench stand (if installed). Slide the
battery cover down in the direction of the arrow.
Remove the exhausted batteries and replace with
two new AAA alkaline batteries. Make certain to
insert the new batteries with the proper polarity as
indicated in the illustration in the battery compart-
ment. Replace the battery cover.
WaRRantY oR SeRVice
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281 482-1714 • Fax 281 482-9448
E-mail [email protected] • www.control3.com
Control Company is ISO 9001 Quality-Certified by DNV
and ISO 17025 accredited as a Calibration Laboratory by
A2LA.