Control Company 4115 RADIO-SIGNAL REMOTE THERMOMETER - Manual (Page 11)

11
HOW TO READ THE KINETIC WAVE DISPLAY
The kinetic wave display shows the signal receiving status of the main unit.
There are three possible forms.
MAXIMUM AND MINIMUM TEMPERATURES
The maximum and minimum recorded indoor temperatures and those of
each channel will automatically be stored in memory. To display them:
1. Select the channel to be checked.
2. Press MEM once to display the maximum temperature. Press again to
display the minimum temperature. The respective indicators (MAX or
MIN) will be displayed. Press again to read current temperature.
To clear the memory, press CLEAR. All segments of the display will light up
for 2 seconds. The display will return to the last screen with maximum and
minimum temperatures erased from memory.
The maximum and minimum temperatures will now be the same value as
the current one until different readings are recorded.
HOW TO USE TEMPERATURE ALARMS
The temperature alarms allow setting upper and lower limits of readings for
individual channels. The alarm will sound if a limit is exceeded. To set the
alarm:
1. Select the channel to be set.
2. Press the HI/LO button for the upper (HI) or lower (LO) limit. An “OFF”
message will be displayed if the alarm for that limit is turned off.
The unit is in searching mode.
Temperature readings are registered.
No signals.