Penn-Century MSA-250-M for Mouse User Manual
Page 13
13
· The thumb button of the plunger is made of anodized aluminum. The syringe
and plunger should never be soaked in bleach (Clorox™or Clidox™) as this
may cause permanent corrosion and/or staining.
· The FMJ-250 High Pressure Syringe can be autoclaved. It should not be heated
above standard autoclave temperatures of 105 - 135 degrees Centigrade.
· The FMJ-250 High Pressure Syringe may also be cleaned with organic
solvents, very hot water, or sonicated.
· Always dry the syringe, put the protective the black end cap on the device before storing
and in the original protective plastic box provided on shipment.
Replacement plungers for FMJ-250 High Pressure Syringe
After long use or from over-pressuring the system, the white Teflon® tip of the syringe plunger
may become worn. One symptom of this is that the syringe may leak from its proximal end (around
the plunger rod). If this happens, a replacement plunger may be purchased from Penn-Century,
Inc. without having to replace the entire syringe. Contact us for details.
ALWAYS test both devices with water if they have been stored and not used for a long period
of time.
For a full summary of the company’s repair and warranty policies, please review the Penn-Century Terms
and Conditions.
As manufacturers, Penn-Century, Inc. can offer:
· Product knowledge
· Operation of our devices
· Familiarity with published studies related to use of the same device and, if possible, similar drugs
· Familiarity with customer feedback about them
These instructions and photos are the property of the Penn-Century, Inc. They must be not be
reproduced without the written consent of Penn-Century, Inc.
IMPORTANT NOTICE: Requirements for references to Penn-Century devices in publications,
abstracts and presentations
As a condition of sale, the Buyer agrees that upon publication or presentation of any research conducted
using a Product, the Penn-Century name as the manufacturer ("Penn-Century. Inc. Wyndmoor, PA") and
the name of the Products must be correctly spelled and cited, and include Penn-Century’s registered
trademark and model number as follows and as applicable: “MicroSprayer® Aerosolizer – Model ___”,
“FMJ-250 High Pressure Syringe”, “Dry Powder Insufflator™ - Model ___” or “Small Animal Laryngoscope
– Model LS-2”. A breach of this section shall result in immediate harm to Penn-Century, and in addition
to any and all rights available to Penn-Century, Penn-Century shall be entitled to an injunction or other
equitable relief as a remedy for such breach.
For any questions, contact us at Penn-Century, Inc. –
Rev. 14Nov2012