Perma Pure MDSS (LLC Integrator Series) - Manual (Page 12)

Section D: Installation
12
The suggested typical System connection method is shown below.
Figure 3 - Typical Connection Diagram
Tubing Connections

Connect the sample inlet port to sample line from the sample pump.

Connect the sample gas outlet to the analyzer via a tee fitting that allows excess
sample flow to be vented.

If required, due to sample gas composition, connect pump (purge) exhaust port to a
tube that allows the system to vent in a suitable location. This is very important if the
sample gas is toxic or corrosive.
Figure 4 - Tubing Connections
Electrical Connections

Connect the system to an appropriate power source while following all local and
regional electrical codes and guidelines.