Audio Design Associates Cinema Reference Mach II PTM-8150 - Manual (Page 101)

Page 100
The Cinema Reference Mach II is capable of being controlled and setup from a special PC program
provided by ADA, the Cinema Ref. II PCOS. You will need to communicate with the Cinema Refer-
ence as outlined in this manual under PC Setup & Control. This section will assist you in understand-
ing the software application.
Appendix E - Cinema Reference Mach II PC Program
When the application is run-
ning, the Main page permits
you set your Com Port, the
Address of the unit (typically
address 00) and the Baud
Rate (1200 Baud Out of the
Box).
The lower portion of the win-
dow permits you to turn the unit
off, mute, unmute/power on.
You can also opt to raise and
lower Volume in either .5dB or
1dB steps as well as Recall
and Store volume presets.
This page also permits you to
recall both Balance and Tone
presets.
The Red and Blue squares are
update information requests
and when pressed, will cause
the Cinema Reference Mach
II to update data based on the
buttons function. As you place
your cursor over the Red but-
ton squares, the type of data
that will be updated will display
in a yellow text box. The Blue
button squares update the in-
formation in the top portion of
the window. This applies to all
screens.
Under the Cinema Mode tab,
the Input Control sub-tab per-
mits selection of both the Main
Input and the Record Input.