Audio Design Associates Cinema Reference Mach II PTM-8150 - Manual (Page 44)

Page 43
The Cinema Reference sports two such triggers and both of these triggers are input specific. The Out
of the Box setup is as follows:
AUX DC TRIG 1 = Engages with all inputs.
AUX DC TRIG 2 = Engages with only the components that have a video inputs:
DVD PLAYER 1, DSS 2, DVR/PVR 3, VCR 4, CABLE/TV 5, AUXILIARY 8, DVD AUDIO 9, CAMCORDER 11, VIDEO
GAME 12, COMPUTER 13, DVD RECORD 14, DSS RECORD 15, DVR RECORD 16, TV RECORD 17, AUXILIARY 2,
& AUXILIARY 3
Since most home theaters using this feature will involve some level of professional setup, you
can alter the Aux DC Triggers using the following steps. If you are planning on adjusting the
Final Input or Input Labels, ADA suggests first making these adjustments prior to proceeding
with the Aux DC Trigger setup.
To setup and verify the Aux DC Triggers:
1 Turn the Input knob to the input label you wish to set the trigger for and press the Input knob.
2 Turn the Mode knob clockwise until the display’s second line reads SETUP MENU and press
the Mode knob.
3 Turn the Mode knob clockwise until the display’s second line reads either AUX TRIGGER1 or
AUX TRIGGER2 and press the Mode knob.
4 Turn the Mode knob to turn the AUX TRIGGER # ON or OFF, then press the Mode knob.
Repeat this step as necessary.
Turn On Input
When controlling the Cinema Reference Mach II from a remote control or control system, the action of
first selecting an input, causes the Cinema Reference to turn on and switch to that input.
However, when turning the Cinema Reference on from its front panel, by pressing the Volume knob,
the Cinema Reference’s Out of the Box default setting will cause it to turn on to the last input that was
used. If you would prefer to have the Cinema Reference turn on to a specific input, every time the
front panel Volume knob is pressed (assuming the unit was off), then follow the steps below. Please
note, that altering the Turn On input from Last Used to a specific device does not affect your ability to
turn the Cinema Reference on to a selected input via its remote control or from a control system.
1 Turn the Mode knob clockwise until the display’s second line reads SETUP MENU and press
the Mode knob.
2 Turn the Mode knob clockwise until the display’s second line reads TURNON INPUT and
press the Mode knob.
3 Turn the Mode knob to select the desired turn-on component and then press the mode knob.
To exit the Setup Menu completely, turn the Volume knob.