Bosch TDS372410E weiß grün Dampfstation Sensixx DS37 ProEnergy - Manual (Page 21)

21
BOSCH
ENGLISH
You can download this manual from the local homepages of Bosch.
Problem Possible causes Solution
The appliance
makes a pumping
sound.
• Water is being pumped into the
steam tank.
• The water tank is not fitted onto
the housing correctly.
• The sound will not stop.
• This is normal.
• Fit the water tank back onto the hou sing
correctly (you will hear a click).
• If the sound will not stop, do not use
the steam generator and contact an
authorised technical service centre.
Loss of pressure
during ironing.
• Steam release button has been
activated for too long a period of
time, that is, it has been pressed
too frequently.
• Use the steam release button at
intervals. This improves the ironing result
as the textiles will be steamed, dried and
ironed properly.
Water spots appear
on the garment
during ironing.
• May be caused by steam
condensed on the ironing board.
• Wipe the textile cover of the ironing
board, and iron any water drops to dry
them.
Water spots appear
on the garment
during use of the
“PulseSteam”
function.
• Water spots are caused by
steam condensation in the hose
when cooling down after use.
• Water drops stop coming out of the
soleplate after using the “PulseSteam”
function for some time.
The hose gets hot
during use.
• This is normal. It is caused by
the steam passing through the
hose during steam ironing.
• Place the hose on the opposite side so
that you cannot touch the hose during
ironing.
Water leakage from
the boiler.
• Drainage plug located at the
bottom of the appliance is loose.
• Tighten up the boiler drainage plug with a
coin.
The iron does not stop
steaming after placing
it on the pad (2).
• “PulseSteam” function has been
activated by double click.
• Just press the trigger once again and the
iron will stop steaming at once.
If the above does not solve the problem, get in touch with our customer service.