Bosch TASSIMO Multi-Getränke-Automat T55 TAS5542 opal black schwarz - Manual (Page 16)

18
Robert Bosch Hausgeräte GmbH
en
Problem Possible cause Solution
Drink size smaller than
usual.
Not enough water in the
water tank.
Fill the water tank after the drink
has finished dispensing and press
the start / stop button to finish the
drink.
The appliance needs
descaling.
Descale the appliance (for details
see “Descaling”).
More steam than usual. The appliance needs
descaling.
Descale the appliance (for details
see “Descaling”).
The appliance does not
recognise the inserted
T DISC and remains in
stand­by mode or the
Status LED
F
lights up
red.
Appliance is not switched
on.
Make sure the appliance is
switched on before inserting a
T DISC.
No T DISC inserted. Check if T DISC has been inserted.
The barcode could not be
detected.
Clean the T DISC barcode reading
window and try again or smooth
the barcode on the T DISC out with
your thumb.
Use another T DISC.
If problems persist contact the
TASSIMO careline
08 00 032 88 33 (UK only)
The brewing system is
not properly closed.
Clean the brewing system thor­
oughly, especially in the area of the
clamp.
The quality of the foam /
crema has deteriorated.
The drink outlet is
clogged or dirty.
Remove the drink outlet from the
brewing unit and detach the pierc­
ing unit. After cleaning everything
thoroughly, reassemble the parts
and replace them in the brewing
unit.
Clean the brewing unit with the
Service T DISC.
The appliance needs
descaling.
Descale the appliance (for details
see “Descaling”).
Brewing unit cannot be
securely closed.
T DISC Piercing unit
or T DISC holder is not
properly inserted.
Insert T DISC holder or T DISC
piercing unit properly.
The T DISC is not
inserted properly.
Re­insert the T DISC and make
sure it is properly positioned.
The brewing unit is not
properly closed.
Push the handle down until it snaps
into place with an audible click.
Clean the brewing system
thoroughly, especially in the area of
the clamp.
Brewing unit cannot be
opened.
The brewing unit is still
locked.
Wait until the Status LED
F
has
stopped blinking before attempting
to open the brewing unit.
TAS55_GB-CH.indb 18 11.01.2013 15:09:59