Asus A8V-VM - Manual (Page 34)

1- Chapter 1: Product introduction
1.10. Internal connectors
1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector is for the provided floppy disk drive (FDD) signal cable.
Insert one end of the cable to this connector, then connect the other
end to the signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection
when using a FDD cable with a covered Pin 5.
A8V-VM Floppy Disk Drive Connector
A8V-VM
R NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
PIN 1
FLOPPY
Refer to the audio configuration table below for the function of the audio
ports in 2, 4, or 6-channel configuration.
Audio 2, 4, or 6-channel configuration
Light Blue Line In Back Surround Back Surround
Lime Line Out Front Speaker Out Front Speaker Out
Pink Mic In Mic In Center/Base
Port -channel 4-channel 6-channel
. USB .0 ports 3 and 4. These two 4-pin Universal Serial Bus (USB)
ports are available for connecting USB .0 devices.
8. USB .0 ports 1 and . These two 4-pin Universal Serial Bus (USB)
ports are available for connecting USB .0 devices.
9. VGA port. This 15-pin VGA port connects to a VGA monitor.
10. Serial port. This port connects a mouse, modem, or other devices that
conform with serial specification.
11. PS/ keyboard port (purple). This port is for a PS/ keyboard.