Bosch Kompakt-Dampfgenerator Sensixx´x DI90 AntiShine TDI903231A anthrazit metallic rosso rot - Manual (Page 22)

20
BOSCH
* Model dependent
EN
gl
ISH
Trouble shooting
Problem Probable cause Solution
The iron does not heat
up.
1. Temperature control (15) set to
minimum.
2. The “SensorSteam” system has
been activated. The iron is set to
stand-by.
1. Turn to a higher position.
2. Grip the handle (1) of the iron to
re-start it.
“SensorSteam”
indicator lamp (3)
flashes.
1. The “SensorSteam” system has
been activated. The iron is set to
stand-by.
1. Grip the handle (1) of the iron to
re-start it.
The lights inside the
temperature control
(15) flash.
1. The soleplate is heating up or
cooling down to the selected
temperature.
1. This is normal and lights will stop
flashing when the selected
temperature is reached.
The clothes tend to
stick.
1. The temperature is too high. 1. Turn the temperature control (15)
down and wait until the iron has
cooled down.
Water drips out of the
soleplate together with
steam.
1. Temperature control (15) setting is
too low.
2. You have pressed the shot of steam
button (7) repeatedly without waiting
for 5 seconds between each press.
1. Turn the temperature control (15)
to a higher setting and wait until the
“TempOK” lights inside the
temperature control stop flashing
and remain lit continuously.
2. Wait 5 seconds between each
press of the shot of steam button.
Steam does not come
out in horizontal
position.
1. Steam control is set to “ ” position.
2. The temperature is too low. Anti-drip
system is activated.
1. Set the steam control to “eco” or
“max” position.
2. Set to a higher temperature if
compatible with the fabric.
Excessive dripping or
steaming.
1. No proper closing of “Calc’nClean”
system.
1. Actuate a few times the
“Calc'nClean” button (16).
The pump does not
work.
1. The iron is not in a horizontal
position.
1. Use the iron in a horizontal
position.
Smoke comes out
when connecting the
iron for the first time.
1. This may be caused by the
lubrication of some of the internal
parts.
1. This is normal and will stop after a
few minutes.
Deposits come out
through the holes in
the soleplate.
1. Traces of lime scale are coming out
of the steam chamber.
1. Carry out a cleaning cycle (see
“Calc’nClean” section).
The appliance makes
a pumping sound.
1. Water is being pumped into the
steam chamber.
1. This is normal.
If none of the above solves the problem, get in touch with an authorised technical service.