AEG LAVAMAT 62600 - Manual (Page 30)

Operating instructions
30
Washing machine
vibrates during opera-
tion or is unstable.
The height adjustable
threaded feet are not cor-
rectly adjusted.
Adjust threaded feet as per
the installation instructions.
There is only very little wash-
ing in the drum (e.g. only a
towelling dressing gown).
Function is not impaired.
Water cannot be completely
pumped out because the
drain hose is kinked
or
the circulation pump is
blocked.
Check the drain hose and if
necessary remove any kink or
clean the circulation pump
and remove any foreign bod-
ies from the pump housing.
Excessive foaming dur-
ing the main wash. Probably too much detergent
was used
Dose detergent exactly in
accordance with the manu-
facturer’s instructions.
Water runs out from
under the washing
machine.
Threaded fitting on the
water inlet hose is leaking.
Tighten the water inlet hose
Drain hose is leaking.
Check drain hose and if nec-
essary replace.
Circulation pump cover is
not closed properly.
Close cover properly.
Washing is trapped in the
door.
Stop program, remove wash-
ing from the door, start a
new program.
Softener is not washed
in, w compartment
for conditioner is full
with water. Suction cap in the compart-
ment for conditioner is not
correctly positioned or is
blocked.
Clean detergent drawer,
place suction cap firmly in
position.
Appliance does not
spin, water in the
drum.
o (RINSE HOLD) selected. Deselect o (RINSE HOLD).
Soaking program is finished.
Pump out the water and set
the main wash cycle as
desired.
Malfunction Possible Cause Remedy