Avery ALS 256 - Manual (Page 34)

30
C
ONTENTS
3.1 E
LECTRICAL CONNECTIONS
ALS
20x
256
GB
Checking the power supply setting
ALS 256: A power supply setting is not re-
quired.
The ALS 20X Label Dispenser is suitable for
operation with a power supply of 230 V (AC) or
110 V (AC).
If you are unsure of what mains voltage your
local electricity supplier provides, refer to a
qualified service technician.
£ Check to see that the voltage that has been set
conforms to the local mains voltage.
[28] Permissible mains voltages for both positions on the voltage
selector switch.
Changing the voltage setting:
£ Make sure that the power cable is
disconnected.
£ Slide the switch [27A] to the respective
opposite position.
– Insert a small screwdriver into the groove [27B] and
move the red insert horizontally to the opposite stop
position (to the left in Figure
[27]).
Connecting the power cable.
£ Make sure that the power switch [29A] is set to ‘O’
(off).
£ Using the supplied power cable, plug the unit into a
socket connected to the mains supply.
For more information on fuses, see section
“Replacing fuses” on page 47.
Switch setting Permissible mains voltage
115 100–120 V (AC)
230 200–240 V (AC)
[27] Voltage selector switch on the ALS 20X (set to 230 V in the
figure)
A B
[29] Power cable (B) plugged in.
B
A